D-32: Exhaust-ing
Got a few various and sundry things done last night. I got the airflow meter and air filter bracket finished up and hung on the car, so I was able to attach the AFM wire. Other than getting the timing going and the distributor mounted, I think we now have all the electrics hooked up on the engine. If not, we’ll know quickly. 
Most notably, I welded up the new exhaust system and test-fitted it. I need to figure out a couple of hanger locations. Also need to test-fit with the tailpipe turn-down and trim that to fit as necessary, then weld that on also. I need to test fit the passenger-side half shaft to make sure that there’s not any interference there (keep fingers crossed), otherwise I’ll need to come up with a couple inches of extension from between the flange at the end of the header to the flange at the start of the b-pipe.
I also ran some new wire for the fan on the oil cooler and cleaned up the switch panel wiring and got the swichgear mostly worked out. May need to add one more switch for the radiator fan but that all depends on if it’s still automatically cycling or not. Still lots to do, hopefully I can crank out some more tonight.
Recent Comments